• Shut the lathe OFF and disconnect power source when removing the faneplste, changing the center, adding or removing an a,zuse. • If the workplece splits or is damaged in any way, turn lathe OFF and remove the workpiece Imm the holders. DiscardFile Size: 1MB. · Set the RPMs to about 1, and start the spindle. You can start even slower and slowly raise the RPMs to 1, during the first few minutes. Set the jaws for the job. Remove the old jaws by loosening them with Allen wrenches and sliding them out and replacing with the . Lathes can be divided into three types for easy identification: engine lathe, turret lathe, and special purpose lathes. Some smaller ones are bench mounted and semi-portable. The larger lathes are floor mounted and may require special transportation if they must be moved. Field and maintenance shops generally use a lathe that can be adapted to manyFile Size: 1MB.
Mount the workpiece into the headstock of the lathe using a holder called “jaw chuck.”. Most of the modern mini-lathe come with a chuck guard. Put that guard on, select the direction of the rotation, and then turn on the lathe. Rotate the lathe at a certain RPM, and don’t ever forget to wear the protective gear. Start the lathe. Release the E-Stop. Press start. Move the spindle speed range lever to high or low. Change the RPM to the calculated value. Move the cutting tool close to the desired starting point. Gently engage the cutting tool. Make the first cutting pass. This may be a good time to 0 the X or Z axis. When removing chucks from the lathe, always use a wooden chuck block under the chuck to support the chuck on the lathe ways. Use care to avoid dropping the chuck on the ways, since this can greatly damage the lathe ways or crush the operator's hands. Mounting Work to Faceplates. Mount faceplates in the same manner as chucks.
Press the E-stop. Clean and clear the lathe. Secure the workpiece. Select and install the cutting tool. Calculate the RPM (speed) for your cutter and. There is a lot of benefit to learning how to run a manual lathe; you get an understanding of how the machine works and how to use it in the best ways. instructions contained in this manual are starkly followed. The users of the machine are therefore, requested to get themselves acquainted with contents of.
0コメント