Goldline actuator manual

ACTUATOR HANDLE OSCILLATES - If you see the handle on your Actuator oscillating back and forth, it may be that the Actuator's two O-rings are not lubricated sufficiently. See our guide on " How To Maintain a Goldline/Hayward Pool Valve Actuator " for further instructions/5(3).  · Goldline Valve Actuator GVA Wiring Diagram. Thread starter looper; Start date ; Forums. Equipment - Build, Use, and Repair. Everything Else. L. looper Well-known member. May 6, #1 Does anyone have a diagram indicating what pin does what on the 3-pin connector? It says in the manual "do not double lug. lation Manual. Aspects of the Aqua Logic that pertain to system setup are not covered in this manual. Automation The AQL-PS-4 (-8, ) can control up to 4 (8, 16) high voltage (/V) pieces of equipment, up to 4 (8 for the PS) automatic valve actuators, and 2 conventional heaters plus a solar heater. Both manual.

valve actuators, and a conventional and solar heater. Both manual and automatic (programmed) operation are available. All of the control functions are programmed at the unit’s display/keypad. Although the ECOMMAND 4 has no built-in chlorinator feature, it can control an external Goldline Aqua Rite or Hayward Swimpure chlorinator. 26 Water Air. The GVA Goldline Valve Actuator rotates 2-port and 3 port valves automatically. Use it with the Aqua Logic system or GL Solar Controller to automate pool/spa operation, solar heating, cleaner operation, water features, or a variety of other uses. 3. On the back side of the actuator, align the smallest slot on the actuator shaft with the smallest slot on the valve diverter. 4. With the two shafts engaged rotate the actuator until holes on the actuator align with the screw holes on the cover. 5. Use four (4) ¼x1½" long screws (packaged with the actuator) to secure it in place.

Goldline / Hayward 3-Way Actuator for automatic solar or pool control. GVA Manual switch is mounted underneath actuator to minimize • tampering. Yep, that's what I thought, and that manual seems to confirm it (since this actuator is compatible with most controllers, using the same. I was a little worried about getting the actuator rotation stop set properly, but it was so simple once you read the manual and look inside the device. Read.